ACT rood 5 meter S/FTP CAT6A patchkabel, rastnasenvrij met RJ45-stekkers

The ACT Red 5 meter SFTP CAT6A patch cable features full copper AWG#26 conductors and 50µ gold-plated RJ-45 contacts, designed for high-speed wired networking. With S/FTP shielding and CAT6A standard, this red 5 m cable supports reliable data transmission for demanding network environments while preserving signal integrity.

Advantages

S/FTP shielding minimises electromagnetic interference and crosstalk, while full copper AWG#26 wires provide consistent conductivity. Snagless RJ-45 connectors reduce the risk of connector damage during installation. Gold-plated 50µ contacts improve corrosion resistance and ensure stable long-term connections. The 5 m length and conspicuous red colour make cable routing and identification easier in patch panels and racks.

Suitable for

• Structured cabling in offices and data centers
• Gigabit and 10 Gigabit Ethernet connections
• Patch panels, switches and network equipment interconnects
• Environments requiring reduced EMI, such as near power cabling

Key specifications

• Cable type: S/FTP CAT6A patch cable
• Conductor: full copper AWG#26
• Contacts: 50 µ gold-plated RJ-45
• Connectors: RJ-45 to RJ-45, snagless
• Length: 5 m
• Colour: Red
• Brand: ACT, MPN: FB6505, EAN: 8716065276572

How to use

Connect one RJ-45 end to the network port of a switch, router or patch panel and the other end to the target device or port. Ensure connectors are fully inserted until the latch engages. Route the cable to avoid sharp bends or crush points and keep it separated from strong power sources where possible to maintain optimal signal quality.

Recommendations

For best performance, use within standard CAT6A installation practices: avoid kinking the cable, maintain bend radius greater than four times the cable diameter, and keep cable runs within supported lengths for your network equipment. Regularly inspect connectors for debris and replace if contacts show wear.