BlueOptics SFP-BXD53-40KM-VA-BO netwerk-transceivermodule glasvezel 1250 Mbit/s

The BlueOptics SFP-BXD53-40KM-VA-BO network transceiver module Fiber optic 1250 Mbit/s is a small form-factor pluggable (SFP) fiber optic module designed for single-channel serial data transmission at up to 1250 Mbit/s. Housed in a metal enclosure and manufactured to meet RoHS environmental requirements, this module is intended for use in optical networking equipment where reliable long-distance connectivity is required. The product's compact SFP interface allows hot-plug installation in compatible switches, routers and media converters.

Advantages

This transceiver offers a standardized SFP form factor for wide compatibility with network equipment from multiple vendors. The metal housing provides mechanical durability and improved heat dissipation, while RoHS compliance ensures reduced levels of hazardous substances. With a rated maximum throughput of 1250 Mbit/s and a weight of approximately 0.2 kg, the module is optimized for installation in rack-mounted and distributed networking systems that require fiber connectivity over extended distances.

Suitable for

Key specifications

How to use

Ensure the host device supports SFP optical modules and is powered down or prepared according to the device's hot-swap instructions. Insert the BlueOptics SFP module into the SFP port until it clicks into place. Connect the appropriate single-mode fiber cable to the module's optical port, observing correct connector type and polarity. If the host supports hot-plugging, monitor link LEDs or management interfaces to confirm link negotiation at the expected data rate. When removing, follow the host device's recommended procedure to avoid connector damage.

Recommendations

Use factory-tested single-mode fiber patch cords with proper connectors and maintain clean fiber endfaces to ensure signal quality. Verify compatibility with the host device's supported wavelengths and optical budgets before deployment. Keep the module within the manufacturer's recommended operating temperature and humidity ranges and handle the unit by the body to avoid contaminating optical surfaces.