SFP AOC-kabel BlueOptics SFP-AOC-10G-10M-AT-BO 10m SFP+ stekker/stekker

The BlueOptics SFP-AOC-10G-10M-AT-BO is a 10 metre SFP+ Active Optical Cable (AOC) with SFP+ male connectors on both ends designed for 10G data transmission over multi-mode fiber. The pre-assembled SFP+ to SFP+ cable integrates transmitters and receivers in the connector modules and conforms to SFP+ AOC MSA electrical and mechanical specifications, providing a plug-and-play fiber connection without separate transceivers or patch cords. The cable supports low-latency, high-bandwidth links over 10 metres and includes digital diagnostic monitoring (DDM/DOM) when supported by the host hardware.

Advantages

The BlueOptics 10m SFP+ AOC delivers 10GBASE-SR class performance with immunity to electromagnetic interference and without the need for separate fiber termination or cleaning of patch cords. Built to MSA guidelines, the cable offers interoperability with major SFP+ ports and provides integrated DDM/DOM for real-time monitoring of supply voltage, laser bias current, transmit power, receive power and temperature where supported. Pre-tested compatibility and industrial compliance help ensure reliable operation and long service life in rack and data centre environments.

Suitable for

• Inter-switch connections in data centres and server rooms
• High-speed uplinks between switches and routers
• Connections to storage systems and SAN equipment
• Short-reach 10G links for enterprise and campus networks

Key specifications

• Form factor: SFP+ to SFP+ active optical cable
• Length: 10 metres
• Data rate: up to 10 Gbps
• Medium: multi-mode fiber AOC with integrated optical transceivers
• Protocol support: Ethernet, Fibre Channel over Ethernet, SDH/SONET (up to 10G)
• Diagnostics: Digital Diagnostic Monitoring (DDM/DOM) support when host hardware permits
• Compliance: Designed to meet SFP+ AOC MSA mechanical and electrical standards; CE and RoHS compliant

How to use

Insert each SFP+ connector into the corresponding SFP+ port on your devices until the latch engages. Ensure both devices support SFP+ AOC modules and, if you require DDM/DOM data, verify that the host hardware exposes the diagnostic functions. No additional transceivers or fiber patching is required — route the pre-assembled cable in the rack or cabinet to avoid sharp bends and secure it to prevent strain on the connectors. After connection, confirm link status and speed on both endpoints using your device management interface.

Recommendations

Use the cable for short-reach 10G connections where a reliable, low-latency link is needed; avoid tight bends (observe minimum bend radius), keep connectors clean and secure cable routing to prevent mechanical strain. Confirm hardware compatibility with SFP+ AOC modules and enable DDM/DOM in the host system if real-time monitoring is required.