Barrow 90°-adapter G1/4 IG naar G1/4 IG TDWT90SN-V2 — Wit

The Barrow 90° Adapter G1/4 IG to G1/4 IG TDWT90SN-V2 — White provides a compact right-angle connection for PC liquid cooling loops. It converts a G1/4 internal thread to a G1/4 internal thread while changing flow direction by 90 degrees, allowing neat tubing routing and reduced stress on fittings and soft tubing. The white finish integrates visually with light-themed systems and offers a low-profile solution where straight fittings cannot be used.

Advantages

This adapter offers a tight-radius directional change without adding length to the loop, minimizing the need for long hoses or additional fittings. Its internal G1/4 threading maintains compatibility with standard water-cooling components, while the right-angle design reduces tension on connectors in compact cases. The white exterior provides a neutral, clean appearance that complements white or light-coloured builds and helps hide minor scratches compared with bare metal surfaces.

Suitable for

• Routing tubing in compact PC cases where space is limited
• Changing hose direction near blocks, radiators, or pumps
• Reducing strain on soft tubing and angled compression fittings
• Creating low-profile connections behind motherboards or drive cages

Key specifications

• Connection type: G1/4 internal thread to G1/4 internal thread
• Orientation: 90-degree right-angle
• Colour/finish: white
• Compatibility: standard G1/4 water-cooling fittings and components
• Form factor: compact, low-profile elbow adapter

How to use

Install the adapter by threading it into the corresponding G1/4 female port on a fitting, block, radiator, or pump until hand-tight, then secure gently with an appropriate tool if necessary. Connect the mating G1/4 fitting or compression adapter on the perpendicular side, ensuring proper sealing with the manufacturer-recommended washers or O-rings. When used with soft tubing, position the tubing to avoid extreme bends beyond the adapter's redirection angle and verify all connections for leaks before powering the cooling loop.

Recommendations

Use compatible G1/4 fittings and inspect seals after installation. Avoid overtightening metal-to-metal threads to prevent damage to threads or adapter housing; hand-tight plus a small additional turn with the correct tool is typically sufficient. Test the loop for leaks at low pressure before regular operation.