Luidsprekerkabel PSSO 3022791G, 2×4 mm, 10 m lengte

Two-core speaker cable PSSO 3022791G, 2×4 mm, 10 m length is designed for connecting loudspeakers to amplifiers and receivers in home and professional audio systems. The cable features two 4 mm² conductors that provide low resistance and reliable signal transfer over a 10 metre run. Flexible insulation and standard polarity marking make routing and installation straightforward while maintaining consistent audio performance.

Advantages

The cable combines a relatively large conductor cross-section with flexible jackets to reduce signal loss and ease handling during installation. Its two-core design ensures correct polarity and compatibility with most speaker and amplifier terminal types. The 10 m length covers typical room layouts without needing joins, minimising potential connection points that could introduce noise or degradation.

Suitable for

Key specifications

How to use

Strip an appropriate length of insulation from each conductor without nicking the copper strands and connect to the speaker and amplifier terminals following the polarity markings. Ensure secure, clean terminations using banana plugs, spade lugs, or bare-wire connections as supported by the equipment. Route the cable away from power cords and sources of electromagnetic interference to maintain signal integrity. Avoid sharp bends and kinking to preserve conductor performance and mechanical longevity.

Recommendations

For best results, match the cable length and conductor size to the speaker impedance and amplifier power. Keep runs as short as practical and use proper termination methods to minimise contact resistance. For permanent or outdoor installations, select cables rated specifically for those conditions.