Schroef Cimco 190040 voor vezelplaten, verzinkt metaal, 35 mm lengte, 4,5 mm schroefdraaddiameter, 1 stk.

Single cimco 190040 screw made of galvanized metal, designed specifically for fastening fibreboard panels. The screw is 35 mm long with a 4.5 mm thread diameter and is supplied as one piece per pack. It is intended for use in furniture assembly, interior fittings and repair tasks where a durable, corrosion-resistant fastener for fibreboard is required.

Advantages

The galvanized finish provides enhanced corrosion resistance for indoor environments and helps prolong service life. The 4.5 mm thread diameter offers good holding power in fibreboard while the 35 mm length is suitable for joining typical panel thicknesses without excessive protrusion. As a single-piece supply, this item is convenient for targeted repairs or small installations where only a few fasteners are needed.

Suitable for

Key specifications

How to use

Select an appropriate pilot hole size for the fibreboard thickness to avoid splitting; pre-drilling is recommended for brittle or thin panels. Position the screw at the desired fastening point and drive it using a compatible screwdriver or a powered driver with the correct bit, applying steady pressure until the screw head is flush with or slightly below the panel surface as required. Avoid over-tightening to prevent crushing the board or stripping the thread.

Recommendations

For best results, use with properly sized pilot holes and consider supplementing with adhesives for load-bearing joints. Store the screw in a dry environment to maintain the galvanised coating prior to installation.