Schroef Cimco 190056 — verzinkte metaalschroef voor vezelplaten, 80 mm lengte, 5 mm schroefdraaddiameter, 1 stuk

Single cimco 190056 screw made of galvanised metal, designed for fixing into fibreboard. The screw is 80 mm long with a 5 mm thread diameter and is supplied as a single piece. It is intended for situations where a corrosion-resistant fastener is required for furniture assembly, repairs, or interior fittings involving fibreboard and similar engineered wood materials. The galvanised steel finish helps reduce the risk of rust in indoor environments.

Advantages

The galvanised metal construction provides corrosion resistance compared with untreated steel, extending service life in typical indoor conditions. The 80 mm length and 5 mm thread diameter offer good holding power in fibreboard while remaining compatible with common drill drivers and screwdrivers. Supplied individually, the screw is convenient for small repairs or when a single replacement fastener is needed.

Suitable for

Key specifications

How to use

Select an appropriate screwdriver bit or drill driver that matches the screw head type. Pre-drill a pilot hole in the fibreboard to the recommended diameter for a 5 mm screw to reduce splitting and to ensure correct thread engagement; the pilot hole diameter depends on the density of the material. Drive the screw straight into the hole until the head is flush or at the desired depth. Use moderate speed and steady pressure to avoid damaging the fibreboard surface.

Recommendations

For best results, use a pilot hole and, when joining thin panels or edging, consider backing the workpiece to prevent breakout. Store the screw in a dry environment to maintain the galvanised protective layer and avoid exposure to harsh outdoor conditions unless additional corrosion protection is applied.