Patchkabel CAT6 U-UTP slank 1 m, blauw, DIGITUS (10 stuks)

DIGITUS CAT6 U-UTP Slim patch cable pack contains ten 1 m unshielded twisted pair slim Ethernet leads in blue. Designed for Gigabit Ethernet and structured cabling, these CAT6 patch cords are suitable for patch panels, switches and wall outlets where short, low-profile connections are required in offices, server racks and home networks. The slim outer diameter and flexible jacket allow neat routing in high-density installations while maintaining CAT6 performance up to 250 MHz and data rates to 1 Gbit/s.

Advantages

The cables use stranded AWG 32/7 bare copper conductors and an unshielded twisted pair design (U-UTP) to combine flexibility with reliable signal transmission. A reduced total diameter of approximately 2.7 mm and a flexible LSZH jacket enable installation in confined spaces and dense cable runs. Molded anti-kink sleeves with strain relief and locking lever protection reduce mechanical stress and protect connectors. The product is manufactured to international cabling standards ensuring compatibility with common network equipment and PoE/PoE+ support for powered devices.

Suitable for

• Connecting patch panels to switches or routers in office and data center racks
• Short horizontal connections to wall outlets in office and home environments
• High-density cabling routes where slim, flexible cables reduce clutter
• PoE or PoE+ powered devices such as VoIP phones, access points and cameras

Key specifications

• Cable category: CAT6, U-UTP (unshielded twisted pair)
• Length: 1 m per cable (pack of 10)
• Transmission frequency: up to 250 MHz
• Data rate: up to 1 Gbit/s (1000BASE-T)
• Conductor: stranded bare copper AWG 32/7
• Insulation: HD-PE (high-density polyethylene)
• Outer jacket: LSZH (Low Smoke Zero Halogen)
• Total diameter: approx. 2.7 mm ± 0.15 mm
• Bending radius: 15 × outer diameter
• Connector: RJ45 plug with molded anti-kink sleeve and locking lever protection
• Operating temperature: -20 °C to +60 °C
• Flame retardancy and smoke emission: IEC 60332-1, IEC 61034
• Typical applications: 10BASE-T, 100BASE-T, 1000BASE-T
• Service life: up to 750 mating cycles

How to use

Insert the RJ45 plug into the device or patch panel port until the locking tab clicks to secure the connection. Route the slim cable along cable management channels or behind equipment to minimize strain and avoid sharp bends below the specified bending radius. For multiple connections, use proper labeling on patch panels and keep cable runs separated from strong electrical interference sources. When disconnecting, press the locking lever and pull on the molded strain relief rather than the cable jacket to prevent damage.

Recommendations

For best long-term performance, keep cable runs within recommended lengths for patching (1 m in this pack) and avoid bundling large numbers of cables tightly when using PoE under high load. Follow standard color-coding and labeling practices when installing multiple cables to simplify maintenance and troubleshooting.